ProBoard BBS Documentation

This is an old revision of the document!

Setting Up ProBoard with Net2BBS

NetFoss was tested with ProBoard BBS for DOS version 2.17 and higher. Replace C for your actual hard drive letter, if you did not use the C Drive. Here is how to configure it:

1. Ordered List ItemExtract ProBoard in c:\pb

A. Create directories for each node such as c:\pb\node1

    and c:\pb\node2 etc.  *THIS IS A MUST!*
B.  Your directory tree should look like this:

	C:\PB
	C:\PB\NODE1
	C:\PB\NODE2 

1. Ordered List ItemCreate a RUNPB.BAT in the ProBoard Directory, which looks like this:

          set proboard=c:\pb
          cd\pb\node%1
          \pb\proboard.exe -B115200 -N%1

  The -B115200 switch tells ProBoard to assume that the caller is
  already connected to the modem at that speed.
  The -N%1 passes the node number, since %1 is replaced with the
  node number when the batch file is run.

3) Unzip the NetFoss files into a directory such as c:\netfoss\ and also
   unzip the included NET2BBS.ZIP into the same directory.
   Copy NETFOSS.DLL into the \windows\system32\ directory.
   This can ONLY be done from a Command Prompt which was opened using
   "Run As Administrator" (right click on its icon to select this) in Windows
   Vista and above.  However this can also be done from dragging NETFOSS.DLL
   in Windows Explorer to the \windows\system32\ folder.

4) Configure a Telnet Server to run the NF.BAT and the RUNPB.BAT
   batch files. If you are using the included Net2BBS Telnet Server,
   then edit your Net2BBS.INI file to use a command line like this:

      Command=c:\netfoss\nf.bat /n*N /h*H c:\pb\runpb.bat *N
      StartPath=c:\pb\node*N

5) For maximum file transfer speed, install Public Domain Zmodem
   (PD ZModem) as an external protocol in ProBoard. This runs several
   times faster then the ProBoard internal Zmodem or FDSZ.

6) Run NET2BBS.EXE, and it is ready to accept telnet connections.